在玻璃鋼橋架施工的時候，是需要做安裝作業的，安裝是一個非常重要的步驟，尤其是由于條件限制的時候，更是要嚴格按照操作規程去做，今天山東橋架小編就給大家整理一下玻璃鋼橋架安裝注意事項有哪些？

During the construction of glass fiber reinforced plastic bridge, it is necessary to do the installation work. Installation is a very important step, especially when conditions are limited, it is necessary to strictly follow the operating procedures. Today, Shandong Bridge Department will sort out the precautions for the installation of glass fiber reinforced plastic bridge?

1.玻璃鋼橋架盡量是不要安裝在有腐蝕性氣體的管道和熱力管道的上面，也不要安裝在有腐蝕性液體管道的下面，不然就需要采取防腐和隔熱的措施，因為如果不采取措施的話，可能就會影響玻璃鋼橋架的使用壽命。

1. Glass fiber reinforced plastic cable tray shall not be installed above the pipeline with corrosive gas and thermal pipeline, nor below the pipeline with corrosive liquid, or anti-corrosion and thermal insulation measures shall be taken, because if no measures are taken, the service life of glass fiber reinforced plastic cable tray may be affected.

2.當玻璃鋼橋架和各種管道平行或者是相互交叉的時候，它們的小凈距離要符合規定的要求，如果玻璃鋼橋架穿過防火的樓板或者是防火墻的時候，要按照設計的要求，采取防火隔離的措施。

2. When the glass fiber reinforced plastic tray and various pipes are parallel or cross each other, their small clear distance shall meet the specified requirements. If the glass fiber reinforced plastic tray passes through the fireproof floor or firewall, fire isolation measures shall be taken according to the design requirements.

3.對于玻璃鋼橋架里面的電纜，在固定的時候，也是需要在規定的部位進行固定的，這個是不能隨意的去固定的，如果是水平敷設的時候，要讓電纜的首端和尾端相隔五米到十米，而且在轉彎的地方也是如此，要隔開一定的距離。當垂直敷設的時候，電纜的固定點的間距，要小于標準的規定的范圍。

3. When fixing the cable inside the glass fiber reinforced plastic bridge, it should also be fixed at the specified position, which cannot be fixed at will. If it is laid horizontally, the head end and tail end of the cable should be separated by five to ten meters, and so should the turning place, which should be separated by a certain distance. When the cable is laid vertically, the spacing between fixed points of the cable shall be less than the range specified in the standard.

4.玻璃鋼橋架里面的電纜，要在首端、分支處、尾端和轉彎，以及每隔五十米的地方，都要設有型號，編號以及起止點等的標記。

4. The cable inside the glass fiber reinforced plastic tray shall be marked with the model, number and starting and ending points at the head end, branch, tail end and turn, as well as every 50 meters.

大家在安裝玻璃鋼橋架的時候，就可以按照上面的方法去操作，尤其是需要按照規定的要求去做好每個細節，這個是不能忽視大意的，如果出現問題，后果是不堪設想的。更多注意事項就來我們網站http://www.yeeones.com咨詢啊。

When installing the GRP cable tray, you can follow the above method, especially in every detail according to the specified requirements. This can not be ignored. If there is a problem, the consequences will be unimaginable. More notes on our website http://www.yeeones.com Counseling.