Ladder type cable tray is a type of cable tray. There are many key points to pay special attention to in the process of re assembly. What are these key points? Next, the manufacturer of Jinan cable tray will explain it to you.
① In the process of horizontal laying of ladder type cable tray, the * * yes span is selected as the support point according to the load curve. The span is usually 1.5-3.0m. In the process of vertical laying, its fixed spacing is less than 2m.
② The distance between generic cabling cables and electrical devices such as motors and distribution transformers where pulse signal interference signals can occur shall be maintained as required, and the distance between generic cabling cables and electrical engineering cables shall meet relevant standards.
③ There are certain standards for the small spacing between the ladder type cable tray and the pipeline.
④ The cable tray is not suitable for laying in parallel with the pipeline below. If it cannot be avoided, the parts of the cable tray should meet many requirements or apply corresponding maintenance methods.
⑤ The spacing between generic cabling cables, optical cables, pipelines and other pipelines laid on the wall shall comply with certain standards.
⑥ In the case of assembly or maintenance in the natural environment of the project, it is unnecessary to think of additional centralized loads. The load distribution of cable metal bridge and tray is uniform according to the weight of the cable itself.
This is the end of the installation specification for ladder type cable tray. If you have any questions about this, you can come to our website at any time http://www.yeeones.com consulting service