托盤式橋架作為一種智能的弱電系統,在我們的日常生活中起著重要的作用。但是它經常會顯示一些問題,并給我們的生活造成混亂。那么,我們知道電纜橋架會遇到什么問題嗎?比如:
濟南電纜橋架的所有部分均顯示出短路現象。
As an intelligent weak current system, tray bridge plays an important role in our daily life. But it often shows some problems and causes chaos in our lives. So, do we know what problems the cable bridge will encounter? For example, all parts of the cable tray show short circuit.
這種故障可能會導致配電柜上的電流繼電器動作,并且電纜損壞非常嚴重。電纜內部短路,通常是由于電纜質量低下引起的。表面不會有任何痕跡。
This kind of fault may cause the current relay on the distribution cabinet to act, and the cable damage is very serious. The internal short circuit of the cable is usually caused by the low quality of the cable. There will be no trace on the surface.
似乎整個電纜都被燒毀或電纜被燒毀,從而使電纜在故障時受到嚴重損壞;可能是電纜橋架中只有一個短路,并且故障處的電纜被打火機損壞,但仍然有明顯的痕跡。
It seems that the whole cable is burnt or the cable is burnt, which causes serious damage to the cable in case of failure; It may be that there is only one short circuit in the cable bridge, and the cable at the fault is damaged by the lighter, but there are still obvious traces.
出現此類問題的原因可能是電流太大或電纜質量太差。使用后須定期檢查和維護所有機械設備。橋梁制造商將討論如何檢修和維護電纜橋架設備。
The cause of such problems may be too high current or poor cable quality. All mechanical equipment must be inspected and maintained regularly after use. The bridge manufacturer will discuss how to repair and maintain the cable bridge equipment.

電纜橋設備的平衡缸運動狀況及其油潤滑系統的油路,接頭等的測試和檢查。托盤式橋架的滑塊和導軌之間的摩擦相對頻繁,應進行必要的調整以檢查接頭和管道的潤滑質量,以確保良好的操作。
Test and check the movement of the balance cylinder of the cable bridge equipment and the oil circuit and joint of the oil lubrication system. The friction between the sliding block and the guide rail of the tray type bridge is relatively frequent. Necessary adjustment should be made to check the lubrication quality of the joints and pipes to ensure good operation.
定期潤滑電纜橋設備的齒輪部件:齒輪箱和內部部件由于頻繁操作而更容易損壞,并且松動的可能性更大。
Regularly lubricate the gear components of the cable bridge equipment: the gearbox and internal components are more vulnerable to damage due to frequent operation, and the possibility of loosening is greater.
此外托盤式電纜橋架開工前,到施工現場實地勘察,確定哪些橋梁需要更換,制作表格,做好詳細記錄。一切準備就緒,托盤式電纜橋架開始施工。吊裝時使用吊裝帶,可以防止施工人員和完好的電纜受到損傷。
In addition, before the commencement of the tray type cable bridge, go to the construction site for field survey, determine which bridges need to be replaced, make a form and make detailed records. When everything is ready, the construction of tray type cable bridge begins. The use of lifting belt during lifting can prevent the construction personnel and intact cables from being damaged.
托盤式電纜橋架更換過程中,應有專人保護,防止與作業無關的人員接近施工現場。拆除嚴重腐蝕的電纜槽,安裝新的電纜槽。將電纜恢復到原始位置,托盤式電纜橋架并更換一段。一切都和之前一樣后,再更換一節,之后會更換另一段。還有什么不明白的地方嗎?可以隨時來我們網站
http://www.yeeones.com咨詢!
During the replacement of tray type cable bridge, special personnel shall be assigned to protect it to prevent irrelevant personnel from approaching the construction site. Remove the severely corroded cable tray and install a new cable tray. Restore the cable to its original position, tray the cable tray and replace a section. After everything is the same as before, replace one section, and then replace another section. Is there anything you don't understand? You can come to our website at any time http://www.yeeones.com consulting service